Swing Hanger NE 4464-1 Set of Two

These Wood Swing Hangers are perfect for mounting swings to Swing-N-Slide Play Sets or DIY wooden swing set kits. Each set includes two 5 3/8" swing hangers and mounting hardware. Easily mounts swing accessories to swing beam. Easily attaches to wood swing beams

Kit Includes:

Installation Instructions

• 1. Drill a 5/16” hole through beam at desired location.
• 2. Counterbore the top of the hole approximately 5/8” deep using a 1-1/8” spade bit.
• 3. Attach bottom beam clamp (slotted) using four 10D galvanized nails or screws.
• 4. Insert swing hanger through bottom beam clamp and beam. Secure using washer and loc nut.
• 5. Attach top beam clamp using four 10D galvanized nails or screws

• WARNING: Improperly closed hooks could cause serious injuries. Close all hooks completely before use! NEVER hang a swing seat by a partial link of chain!

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Continue