Sale
Glider Support Only - Residential

Glider Support Only - Residential

Brand: Jensen
Product Code: GS
Availability: In Stock
$59.99 $54.88 & Free Shipping
  • Residential use only
  • Hardware is NOT included

    Installation instructions.
  • If your swing set has a single beam across the top, you may need to install a GS glider support. This will produce a four point mounting system. The flat piece with one hole goes on top of the beam and the side with two holes bolted flush against the beam. You will need to drill holes into the beam in order to install the bolts. The bolts should be 2 at1/2" x 3" lag bolts and the top bolt should be 1 at 1/2" and then whatever the depth your beam is. This bolt needs to go through the beam from the bottom of the beam and have a nut attached to it on the top of the beam.
    4 - 2 1/2" hangers will go through the four end holes. The nuts should be attached on the top of the assembly with the swing hangers at the bottom of the assembly. The spring clips should be attached to the swing hangers and then attached to the glider.

Write a review

Note: HTML is not translated!
Bad           Good
Most Viewed
Best Seller